Netgear genie smart setup ex27002/18/2024 ![]() BT Home Hub 2's "Wireless Association" button is not for WiFi WPS, but for the association with a DECT phone. The "Wireless Association" technology being used by BT Home Hub 2 is different from the WPS of the NETGEAR extender. My NETGEAR WiFi extender won't connect to my BT Home Hub using WPS, am I doing something wrong? Please connect to EX2700 through wired, and login at, and check the wireless setting page.If you still cannot access the extender, please reset it back to factory default. What can I do in order to access the EX2700? I entered a wrong wireless security passphrase during installation, I cannot connect to EX2700 through wireless. If your router has MAC filter (ACL) on it, please follow the FAQ 7 to complete the installation. The EX2700 does not use the WPS protocol to connect to your router. You don’t need to change anything on your router. Please add all MAC addresses shown on the “Virtual MAC address” column into your router.ĭo I need to enable WDS on my router when I install the EX2700? Once you have completed the installation, go to GUI (), select the “Attached device” option on the left page and it will show the information which each computer attached to EX2700. Please disable MAC filter on your router temporarily when installing the EX2700. I have enabled wireless MAC filter (wireless access control) on my router, what should I do when installing EX2700? The default login name (case sensitive) is admin and the default login password(case sensitive) is password. What is the default login name and password to administer the Extender? Within 2 minutes, press your router or your PC’s WPS button. To use WPS to connect the extender to your router or your PC, first, press EX2700’s WPS button. The Push ‘N’ Connect button can be used to connect the Extender to your existing router or connect your PC to the Extender. Stick a paper clip into the reset hole on the back of the unit and hold it until the Extender status LED flashes amber.Ĭan I use the Push ‘N’ Connect WPS button to connect the Extender to my existing router? How do I set the unit back to factory default? NETGEAR recommends that you only connect through the Extender network when the PC is in a “dead zone” where connection is very poor or non-existent from the existing network. Why is it recommended that I only connect to the Extender when the existing network does not provide good connection?īecause data traffic routed through the Extender network is inherently slower than traffic routed directly from the existing network, the PC should stay on the existing network if the connection is good enough. ![]() Then open a new browser and type the URL. ![]() ![]() If you still cannot access the Extender, close your browser. Make sure you are on a PC that is connected to the Extender network and your PC is configured as DHCP client mode. How do I change my setup after the Extender is up and running? The new and most up-to-date firmware will likely correct issues as well as potentially add new and improved features to the product. Having the latest firmware will help increase the stability, functionality and performance of your product. Why do I need to always have the latest firmware on my NETGEAR product? On the other end, wirelessly connect the Extender to the PC-in this case, the Extender functions as an access point. The proper usage of the product is to wirelessly connect the Extender to the existing router-in this case, the Extender functions as a client. Universal WiFi Range Extender is designed to work as an AP/client bridge, not an access point. Will the Extender work if I connect it to the existing router with an Ethernet cable?
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |